Debugging method of rotary fan

Debugging method of rotary fan After the rotary fan is installed in place, first remove the air inlet filter and pour about 30ml oil into the main engine to make the engine oil evenly distributed in the main engine. Rotate the main pulley by hand to make the engine oil evenly lubricate the inner wall of the fan.Before starting the rotary fan, please confirm whether the V-belt is loose properly. If it is too loose, please adjust it. Make sure that the relief valve is set at the specified pressure position. During commissioning, the exhaust valve can be adjusted manually to increase the opening pressure, adjust the safety valve and open it immediately. Before starting the rotary fan, the sewage treatment tank must be filled with water before the rotary fan can be operated. Otherwise, if there is no pressure at the outlet of the rotary fan, the rotary fan will not be lubricated. Turn on the power fan and confirm that the rotation direction of the rotary fan is consistent with the rotation mark direction. In case of inconsistency, disconnect the power supply immediately and adjust the motor wiring.Observe whether there is pressure indication on the pressure gauge, observe the oil dripping from the nozzle, observe whether there is oil flow in the transparent oil return pipe, check whether all parts of the motor and fan work normally, whether the temperature is normal, and whether there is abnormal sound.CL Sereis Cone Liquid Ring Vacuum PumpRotary Vane Vacuum PumpDry Scroll Vacuum Pump